Record Details

High accuracy measurements of magnetic field integrals for the european XFEL undulator systems
Two high accuracy moving wire (MW) measurement systems based on stretched wire technique were built for the European XFEL (XFEL.EU). They were dedicated to monitor, tune and improve the magnetic field integrals properties during the serial production of the undulator segments, phase shifters and air coil correctors for XFEL.EU. For the magnetic tuning of phase shifters and the calibration of the air coils correctors a short portable MW measurement bench was built to measure first field integrals in short devices with magnetic length of less than about 300 mm and with an ultimate accuracy much better than 1 G cm (0.001 T mm). A long MW measurement setup was dedicated to obtain the total first and second field integrals on the 5-meters long undulator segments with accuracy of about 4 G cm (0.004 T mm) and 2000 G $cm^{2}$ (20 T $mm^{2}$) for the 1st and 2nd field integrals, respectively. Using these data a method was developed to compute the proper corrections for the air coils correctors used at both extremities so that zero first and second field integrals for an undulator segment are obtained. It is demonstrated that charging air coils correctors with these corrections results in near zero effect to the electron trajectory in the undulator systems and consequently no negative impact on the self-amplified spontaneous emission (SASE) process should occur.
Amsterdam, North-Holland Publ. Co., 2016
Journal Information:
Nucl. Instrum. Methods Phys. Res. A, Vol. 833, p. 54 - 60 (2016)
External related publications:


 Record created 2016-10-11, last modified 2017-04-24

Download fulltextPDF
External link:
Download fulltextFulltext
Rate this document:

Rate this document:
(Not yet reviewed)